seaming carpet::In fact, all you need is some information, tools and equipment that you can rent, plus the will to accomplish the job seaming carpet

seaming carpet::In fact, all you need is some information, tools and equipment that you can rent, plus the will to accomplish the job!
Tools and materials preparing your floors installing carpet begins with preparing your floors.
If you have a wooden floor, a thorough sweep or vacuum should do the trick.
Nail down any loose floorboards.
To do this, wet the floor.
The area of the floor that dries first will show you where your ducts are.
Mark these areas with chalk so that you can avoid sinking nails into the area during carpet installation.
Installing tackless strip the first step in laying carpet is to install the tackless strip.
Cut the tackless strip to fit the length of each wall.
Nail the strip using masonry nails.
The pins should point toward the wall.
Make sure that the strips join together at the corners of the room.
Remember not to install tackless strip by the sides of the door!
Installing carpet padding the next step is to install the carpet pad.
You need the cut the carpet padding in strips long enough to reach the tackless strip.
Make sure that the waffle side of the carpet pad is facing up.
Staple the carpet padding every 6 inches.
Let the glue dry completely before moving on to the next step in order to prevent the carpet padding from bunching up.
Remember that the carpet padding should not overlap, but rather should butt together.
Cover seams with duct tape.
Cut off any excess carpet padding.
Cutting the carpet when cutting the carpet, you need to remember a few points regarding the texture of your carpet.
Take one end and draw a straight chalk line along the back.
Now lay this over the uncut carpet and use it as a guide with which to trim the adjoining carpet piece.
Cutting and placing your seaming tape cut the seaming tape to measure the length of your carpet seam.
Make sure that the adhesive side of the seaming tape is facing up.
Center it under the butting edges of the carpet.
Now get your seaming iron ready.
Heat the seaming tape by slowing dragging the iron over the tape.
As soon as an area of seaming tape is heated, press the adjoining edges of carpet over the tape.
Push the teeth of the knee kicker into the carpet approximately one inch from the wall.
This will firmly hook the carpet onto the tackless strip.
Attaching carpet with the power stretcher the purpose of the power stretcher is to attach the carpet to the wall.
Place the bottom of the power stretcher approximately six inches from the wall, using a piece of scrap carpet or padding to protect the wall.
Stretch the carpet and hook it onto the tackless strips.
Repeat this procedure around the room.
Use your trimmer to cut off the excess carpet.
Install the gripper edge according the directions on your package.
Go brag about your carpet installation knowhow to all your friends!
seaming carpet::Carpet rolls generally come in 12foot widths, but not
every room is 12 feet wide seaming carpet